CAN to TTL Serial Communication Module PC6-01 Pneumatic Push in Bowden Extruders for 3.0mm J-Head fitting Ready to power your next

Ready to power your next project

35C discharge rate ensures reliable power delivery under demanding flight conditions

3V-referenced TX/RX pins

If your sensor fails during normal use

These drivers accept logic-level step and direction signals from microcontroller GPIO pins and provide the necessary current amplification to drive the motor coils

CAN to TTL Serial Communication Module PC6-01 Pneumatic Push in Bowden Extruders for 3.0mm J-Head fitting Ready to power your nextCAN to TTL Serial Communication Module CAN to TTL Serial Communication Module 3. 3V 5V This is an CAN to TTL Serial Communication Module. The module uses a black backplane high quality circuit board, Which Comes standard 3. 50mm Screw Terminal connector on the end, on the other end has a 5pin headers. There is a power light on the board to indicate the power supply status. The onboard voltage regulator chip supports 3. 3 5V wide voltage power supply.